How to make two handles on the same facade?

Sometimes it may be necessary to make two handles on one furniture facade at once. For example, on a wide drawer. And cranking it is very easy!


We go inside the kitchen module by double-clicking the mouse. Then also double-click to go deeper to the handle itself (in the handle settings window there should be a red inscription "✅ Hot swap function is available").

In its parameters, we change the position of the handle so that it is left or right. You can also set more horizontal indentation. We apply and the handle will shift to the side.

Now copy this pen. The most convenient combination is Ctrl+C and Ctrl+V. We put it in any place and in the position parameters we set the other side.

Everything is ready. Now you have as many as two handles on the same facade!

Watch the gif!

Two handles on one furniture facade

GIF

Click to see the animation

Additional Information:

You may notice that the sides of the position of the handle module do not coincide with reality. For example, you set "Center left", and the handle is centered right. This is due to the fact that the facade module implies opening in different directions and therefore rotates depending on the parameters specified in it.

This inconsistency is leveled inside the facade parameters. Therefore, if you set the position of the handle in the facade parameters, then the handle is positioned correctly, in accordance with the specified parameters.

If you liked the article, please rate it. Click on the star!

Rating 0.00 (0 Votes)
Be the first to comment

Other interesting articles:

How to make a roof instead of crossbars?

How to make a roof instead of crossbars?

Оставить отзыв
There is a quick and easy way to replace the standard cross-pieces of kitchen modules with a whole p...
Read More
How to make inset facades?

How to make inset facades?

Оставить отзыв
Sometimes it is required to make an inset facade. This is quite easy to do using the local parameter...
Read More
How to edit the geometry of panels?

How to edit the geometry of panels?

Оставить отзыв
Quite often it is necessary to give non-standard forms to furniture details: to make fillets, bevels...
Read More